Setup:
One Hatchet
A Beetle or Packy
One LOG of each wood type in your backpack
One BOARD of each wood type in your backpack
One special LJ resource (Bark Fragments, Crystal Shards, etc) of each type in your backpack
Create a Macro:
1) Target as resource (when the box shows up, drag the hatchet in)
2) Delay 1s (you can adjust this based on your lag and connection)
3) Hatchet (Drag in the hatchet again)
4) Wait for Target
5) Target as Type (when the box shows up, drag a LOG of wood)
6) Delay 1s (you can adjust this based on your lag and connection)
Repeat steps 3 thru 6 for every wood type, then close the Macro.
This Macro gets your logs and cuts them into boards to save weight.
Add an Organizer Agent:
Use "Add as Type" for each BOARD wood type you have in your backpack.
Use "Add as Type" for each special LJ resource you want to transfer to packy.
Set the default container as your beetle or packy.
This agent will automatically move your boards into your packy. You have to start it manually clicking it from your backpack (the bottom-left pointing arrow).
You can even run these at the same moment, the organizer will keep moving your boards as you make them into the packy until it is full. If you have a good connection you'll keep hacking and storing at the same time
To learn how to create an Agent, or a Macro, please refer to the Pinco Ui's Guides. If you have question about these macros, fill free to ask here.
I use them all the time, so i know they're working.
One Hatchet
A Beetle or Packy
One LOG of each wood type in your backpack
One BOARD of each wood type in your backpack
One special LJ resource (Bark Fragments, Crystal Shards, etc) of each type in your backpack
Create a Macro:
1) Target as resource (when the box shows up, drag the hatchet in)
2) Delay 1s (you can adjust this based on your lag and connection)
3) Hatchet (Drag in the hatchet again)
4) Wait for Target
5) Target as Type (when the box shows up, drag a LOG of wood)
6) Delay 1s (you can adjust this based on your lag and connection)
Repeat steps 3 thru 6 for every wood type, then close the Macro.
This Macro gets your logs and cuts them into boards to save weight.
Add an Organizer Agent:
Use "Add as Type" for each BOARD wood type you have in your backpack.
Use "Add as Type" for each special LJ resource you want to transfer to packy.
Set the default container as your beetle or packy.
This agent will automatically move your boards into your packy. You have to start it manually clicking it from your backpack (the bottom-left pointing arrow).
You can even run these at the same moment, the organizer will keep moving your boards as you make them into the packy until it is full. If you have a good connection you'll keep hacking and storing at the same time
To learn how to create an Agent, or a Macro, please refer to the Pinco Ui's Guides. If you have question about these macros, fill free to ask here.
I use them all the time, so i know they're working.