Good lord!

[KoolAidAddict]

Cant seem to figure out how to break my dang soulforge.

Im wanting it on the first floor.
I removed the second floor flooring tiles.
I put down two rows of gozas.
I raised the first set of gozas all the way up.
I placed the soulforge on top of those.
I raised second set up to one spot below first set.
Lowered bottom one, then top one (gozas that is).
Stupid soulforge wont come down(break).
Crap.
WT??????

Am I doomed to have this monstrosity of an ugly piece of &*%$ sucking up all my floor space?

Help!!!

 

[Lady Michelle]

axe it breaks it i think your not suppose it axe it, I think your suppose to lower the pieces you dont want and hide them.

 

[anvira]

I believe that in a custom home you can't put it on the first floor (something to do with space..not sure).

Here's a link in which Sarsmi explains how to officially 'break' a soulforge and some other helpful information from folks that have successfully/not completed this.

http://vboards.stratics.com/showthread.php?t=156766&highlight=soul+forge

Hope it helps!

 

[Tazar]

You can put on on the first floor - but it seems you must have a 2-story tall room to do it.

 

[CassieDarksong]

I placed one in my luna home in a one-story tall room. I had no issues placing it.

 

[Tiny Dancer]

Koolaid, did you say you did two rows of gozas? That might be your problem right there. If you have already gone to the tutorial you might have already fixed this but if not, you only need to do 16 gozas, raise them up place the soulforge, lower one of the gozas and the forge will "break". Someone suggested making the goza you want to lower you last object to make it a little easier and that does help if you don't use the EC. Make sure you lock down the remaining pieces of your forge before going back into customize mode to replace your tiles on the second floor.

 

[Sarsmi]

I just did this in a house, I ended up having to remove a 5x5 area of floor tiles above the soulforge area, then i placed a 4x4 square area of goza mats, raised them all up two times, placed forge, then lowered a goza 2 times to break it, then chopped all the extraneous bits. Locked down both sides of the anvil and went back into custom mode to replace the floor. Easy as moderately difficult pie!

 

[Gheed]

Why chop them up? Just make use of the dead space. Spice them up a little.

My improved soulforge:

 

[KoolAidAddict]

Thanks to all for inputs.

Someone in chat helped me figure it out.
Wish I could remember name to pay respects, but trust me I did in chat!!

It was simply that I was raising the gozas too high.
Yes only one set of 16 gozas, dumb of me to think it took two! (doh!)
Only raise them two times and bingo!!
Now its lookin mighty fine!!
I chopped the middle out of it so I could have a surround soulforge!

 

[Tiny Dancer]

Thanks to all for inputs.

Someone in chat helped me figure it out.
Wish I could remember name to pay respects, but trust me I did in chat!!

It was simply that I was raising the gozas too high.
Yes only one set of 16 gozas, dumb of me to think it took two! (doh!)
Only raise them two times and bingo!!
Now its lookin mighty fine!!
I chopped the middle out of it so I could have a surround soulforge!

Lol... If you are on the Atlantic shard that was actually me... You expressed your gratitude very well!